+7 (903) 888-08-12 ПН-ПТ с 9-00 до 18-00 (МСК)

Whole-milled fillet clamp (set)

5,490р.

- +

Fillet whole-milled Profile clips are designed to fix knives with a butt thickness of up to 3.5 mm. The shape of the outer surface is radially convex, allows you to set minimum sharpening angles. The minimum sharpening angle is 7.2 degrees. The clamps are made of a single piece of aluminum, allow you to adjust the clamp to any shape of the blade and ensure the symmetry of the installation. Thanks to the two gripping points, the deflection of the blade is excluded. It is possible to move the clips independently, along the entire length of the frame. There is no need for calibration. With these clips, it becomes possible to sharpen knives with "Scandinavian descents" along the line of descents. Suitable for table and sirloin knives with a narrow butt. They make it possible to sharpen: kitchen knives, sirloin knives, keychain knives, dangerous razors, knives with "scandi-descents" and other narrow long knives.


Recommended length of knives: 30-300 mm

Minimum knife width: 10 mm

The thickness of the sponges at the ends: 1 mm

Clip width: 21 mm, 2 pcs.

The gap between the sponges in the free state

Tags: whole-milled fillet clamp set, ts-pt2000172, tsprof sharpening, clamp, series profile

Subscribe to our accounts!

Be aware of all new products and reviews!

Sharpening device "Profile"
card-mastercard card-visa webmoney qiwi yandex-money